Wednesday, June 03, 2009

Seting some standards

After some making circuits with different type's of support (including no support) I decided to set myself an standard on PCB experimental board's so everything looks the same.
I buy PCB on 20*30 (cm) chunks so after some complex math....(rest should give 0) I set on 10*6 (cm) which give's me 10 smaller PCB's, enough for a 5 conversion super duper heterodyne transceiver :)

From left to right some of the boards in fabrication process: RF pre-amp (to be brewed), First mixer, attenuator, audio amp.

I placed in each board 2 holes for fixing inside their box.

No comments: