Sunday, April 15, 2018

Mains power meter and rig energy consumption.

Got this meter some time ago, idea was to place in a box with a current switch to act as mains shack power outlet, letting me measure actual power consumption of the equipments when in use.

Meter was bough out of the "bay", rated to 20A, it has 2 input and 2 output power terminals. Here Some initial testing with it:


It also has cumulative power consumption besides the other values.

I placed, this Easter when in vacation in Portugal, on a standard electrical box along with the circuit breaker rated for 6A, sure I will not need more at the moment.

The advantage is I can shutdown all the shack power from one single point while also monitoring mains values.

And bellow the measure rating for some of the equipments currently connected.

Winer is the FT-102 without tube heater on, add around more 30w for that. "Only" in RX mode:



Then the FT-307/FT-107:


..same power as the light bulb in the first picture.

Lowest power consumption goes for the "Speaky" transceiver:




The "Speaky" power supply, a Yaesu one, takes 1.8W so the actual power is lower than the 8.4W:

Both the FT-307 and FT-102 have internal power supply.

The big surprise is the Kenwood power supply, I suspect there could be some leakage at the caps .as a reason for the almost 14w.




I didn't check transmitting power consumption since the FT-307 has a fault in the PA and the FT-102 is now developing a receive fault, I suspect a cap in the AGC path. Will have to fix one of this days.

This is a good reminder to run more time on the "Speaky" transceiver so save energy.

Have a nice day!

No comments: